Dings-dynamics-group 60 Series Coupler NEMA 4X Bedienungsanleitung

60 Series Double C Brake InstructionsNEMA 4X Washdown HousingG061032Read carefully before attempting to assemble, install, operate or maintain the pro

10Figure 10

REPLACEMENT PARTS LIST11*The number of rotating discs is shown in the brake model number. Example 6-62006-5155has two rotating discs. The number of st

SPECIFICATIONSTorque: 1-1/2 through 20 lb. ft.NEMA Motor Frame Sizes: 56C, 143TC, and 145TC.Enclosure: Aluminum with steel wrap coverVoltage: All NEMA

WARNING:Brake performance and features must be carefullymatched to the requirements of the application. Consideration must be given to torque requirem

For models with one-piece shaft design:1. Place 3/16” square key furnished into motor keyway.Key must extend to, and be flush with, end of motorshaft.

4MAINTENANCECaution: Before attempting to service or remove any components, make certain that the power is disconnectedand that the load is completely

Torque AdjustmentCaution: Load to be removed or blocked. Brake may beinoperative during this procedure.The magnetic disc brake is factory set for rate

Armature Plate Assembly ReplacementCaution: Load to be removed or blocked. Brake will be inop-erative during this procedure.Refer to Figs. 3, 6 and 10

7Manual Release AssemblyRefer to Fig. 7.1. Adapter housing (7) must be removed to replace manualrelease assembly. Remove adapter housing (7) per“Frict

VERTICAL MOUNTINGInstallation and AdjustmentInstallation and adjustment of the vertically mounted brakeis the same as on the standard model.Friction D

SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTIONBrake does not release 1. Broken or damaged parts 1. Replace.2. Wrong voltage 2. Check for correct voltage. Vo